These general European rules apply to securing cargo in an LCV:

1. The bulkhead must be serviceable (undamaged and strong enough)
2. The support of a sliding tarpaulin (if present) must be serviceable, and all planks must be in place
3. Wear and corrosion of lashing points should always receive expert attention
4. Sufficient lashing anchor points must be available on the vehicle
5. Lashing Equipment must be undamaged, clean and serviceable

Loose components in vehicle

All obligations that apply to other road freight traffic apply to the safe securing of cargo in a van. The goods must be secured so that they cannot move while driving, including when taking sharp turns or braking abruptly. This applies to any van, including the commercial vehicle of a plumber, contractor or electrician, whether it is open, closed or fitted with a tarpaulin-lined cargo box.

Extra care when securing cargo in vans is necessary because these vehicles are often subject to more acceleration than trucks. The engine power of a van often allows for forceful acceleration and fast cornering. Great care in distributing weight and securing goods is needed to avoid injuries or damaged cargo.

Bulkhead

Usually in vans there is a separate cargo area from the driver's cabin by a reinforced or unreinforced bulkhead.

Sheets of furniture are often used for reinforcement. A glass screen in the bulkhead allows the driver to look to the rear, but it is very vulnerable. Especially with pointed objects like metal pipes that can easily break through it during abrupt braking.

Side walls

Most vans are composed of metal sheeting on a frame. Tracks systems can be attached to this frame, containing holes that can be used for attaching lashing straps. This allows goods such as boxes, barrels and crates to be secured individually to the wall.

Anchor points

Vans are fitted with anchor points in the loading floor and side walls. These can be used to attach straps or nets. Separate tie-down rails (usually aluminum airline rails) can be attached at heights and widths appropriate to the type of transport. When securing cargo, attention should be paid to the maximum load on these points. This includes not only the force when lashing straps, but especially the centrifugal force created when cornering at a somewhat higher speed. If a lashing strap breaks and the load comes loose, this can lead to major damage to the goods and the vehicle.

As in trucks, care should be taken to ensure that the hooks are suitable for the anchor points. The hook should fit effortlessly into the lashing eye and not be too big or too small, because if the hook can come loose, the lashing has no use.

Compartments

Couriers who deliver many parcels often face the problem that it takes too much time to re-secure the remaining load after each delivery. They often just shuffle the boxes a bit in the hope that they will not slide around too much during the journey. In urban distribution, high speeds are not usually achieved, but a stretch of ring road can still easily be part of the journey. Sharp turns and abrupt braking always occur. 

A time-saving solution here is to form compartments by attaching partitions, low, semi-high and high partitions are available, which can be attached to the body of the van by means of pillar systems. The partitions themselves can consist of boards, plates or latticework. With a second, raised loading floor, horizontal compartments can also be created. For example, long items such as pipes or tubes can be stored under the loading floor, with smaller items above it.